DD-WRT Repeater Bridge 設定筆記WL-500g

DD-WRT Repeater Bridge 設定筆記WL-500g

Broadcom的CPU才有支援Repeater Bridge。

http://www.dd-wrt.com/wiki/index.php/Repeater_Bridge

http://digiland.tw/viewtopic.php?id=886


這個步驟最清楚：
http://www.dd-wrt.com/wiki/images/9/9b/Repeater_Bridge.jpg

1.恢復DD-WRT原廠設定
save > apply
2.Wireless -> Basic Settings
* Physical Interface Section
o Wireless Mode : Repeater Bridge
o Wireless Network Mode : Must Match Primary Router
o Wireless Network Name(SSID) : Must Match Primary Router - Make
sure you spell this correctly
o Wireless Channel : Must Match Primary Router (This will disappear
once you put it in RB mode, and isn't needed)
o Wireless SSID Broadcast : Enable
o Network Configuration : Bridged
o Save
* Virtual Interfaces Section
o Add
o Wireless Network Name(SSID) : Different from Primary Router
+ [NOTE] - You CAN try using the same SSID but it usually
will not work properly. Many have had random disconnects and/or no connection
if the SSID's are the same. If using the same ssid doesn't work for you, use
a different ssid from the primary router
o Wireless SSID Broadcast : Enable
o AP Isolation : Disable
o Network Configuration : Bridged
o Save

3.
Open the Wireless -> Wireless Security tab

* Physical Interface Section
o Security Mode : Must Match Primary Router and DD-wrt only works
reliably with WEP or WPA2-AES
o WPA Algorithms : Must Match Primary Router
o WPA Shared Key : Must Match Primary Router
o Key Renewal Interval (in seconds) : Leave default
* Virtual Interfaces Section (note if you don't see this section your
firmware should be atleast v24-sp2)
o Security Mode : Must Match Physical Interface
o WPA Algorithms : Must Match Physical Interface
o WPA Shared Key : Must Match Physical Interface
o Key Renewal Interval (in seconds) : Leave default
o Save

# Open the Setup -> Basic Setup tab

* Connection Type will be: Disabled
* Set STP for Disabled (Enabled sometimes can cause connection problems)
redhawk
* IP Address : 192.168.1.2 (Assuming Primary Router IP is 192.168.1.1)
* Mask : 255.255.255.0
* Gateway: 192.168.1.1 (again assuming Primary Router IP is 192.168.1.1)
* DHCP Server: Disable
* Local DNS: 192.168.1.1 (if IP of Primary Router is 192.168.1.1)
* Assign WAN Port to Switch : Optionally enable this to use the WAN port
as another LAN port.
* Save

# Log back into the router at it's new IP address of http://192.168.1.2

* Open Setup -> Advanced Routing tab
* Set Operating mode to "Router"
* Save

# Open Services

* Disable Dnsmasq
* Save

# Open the Security -> Firewall tab

* Uncheck all boxes...except Filter Multicast
* Disable SPI firewall
* APPLY Settings